A650E TRANSMISSION PDF

AE[edit]. 5 Speed Automatic Transmission. I6 and V8 versions similar. However V8 versions have slight internal upgrades to handle. One of the most common misconceptions about the IS (and other cars that share the 5 speed Lexus automatic) is its ability to handle some. AE AT (RMU). TERMS. ABBREVIATIONS USED IN THIS MANUAL. Abbreviations. Meaning. A/T. Automatic Transmission. ATF. Automatic Transmission.

Author: Meztibar Nat
Country: Costa Rica
Language: English (Spanish)
Genre: Software
Published (Last): 13 March 2012
Pages: 118
PDF File Size: 16.39 Mb
ePub File Size: 16.41 Mb
ISBN: 687-8-41915-805-8
Downloads: 69124
Price: Free* [*Free Regsitration Required]
Uploader: Sarg

One of the most common misconceptions about the IS and other cars that share the 5 speed Lexus automatic is its ability to handle some real power.

In this article, I will outline what it takes to make it handle some power on tranmsission cheap, mods that almost anyone can do.

Toyota A transmission

Everyones mileage will vary, no doubt, and part of its longevity rests with you, the driver, but this will be the best thing you can do without spending a ton of money. There are a few theories on how to make automatic transmissions last. I knew, going in, that my stock transmission might not last too long, so I was prepared to do some experimenting. What I have ended up with is a transmission that was amazing at a whp level over ft lb of torque alsoand today, is still holding up to whp, once in 3rd gear and above.

I have not modified the valve body in any way and the transmissions guts have never been removed. The transmission pan and valve body will need to be removed, but that is it really. Well, I did a bunch of research and found that it is a delicate balancing act to make these transmissions work right with some real power behind them.

The first problem I ran into was hitting the rev limiter under power. Stock rev limiter is around and the transmission starts its shift around There are two ways around this — raise the rev limiter or make it shift faster.

  JANEZ RUGELJ PDF

The best way without a full transmission build, and even without a valve body replacement is to modify the accumulators. Accumulators are the small piston like devices that allow fluid to accumulate, in order to dampen shifts.

The springs need to be stiffer to make the shifts firmer, but they still need to be trajsmission place to maintain a little bit of shift damping. There is no need to be chirping tires for a quarter throttle shift.

I was never able to find good information on stock spring rate, or even find a good source for stiffer springs that would fit properly. Instead, I simply shortened the space the spring could travel.

Unfortunately, I do not have measurements, as I simply did not take them when I was performing this mod 3 years ago. Some day, I will pull her apart and get exact measurements. To shorten the travel, I simply transmissoon bushings for the springs. Anything metal that fits inside the accumulator will work.

I shimmed all 4 of mine approximately 15 mm. That was attempt 2.

History of the AE Transmission | It Still Runs

There are small holes inside the accumulators that you do not want to block, but the a design prevents that to an extent. One more transmixsion mod related to this is to simply turn line pressure up. On the side of the valve body, there is a pressure control — simply use a straight edge screwdriver to push in and rotate to the next detent.

The second part includes raising the rev limiter and a few other little tricks. Even with the above listed modifications, getting the trans to shift too quickly will not be good. At the power levels required for these types of modifications, hopefully you are running some sort of standalone already. The 2jz is very capable of spinning higher than the stock rpm redline.

  ACOUSTIC IMPROVISATION FRANK GAMBALE PDF

One other thing I do is retard timing during the shift. This reduces power just slightly low timing keeps the turbo spooled though until the lower RPM after the shift point is realized and the timing is obviously much higher there. It is my opinion that these rods that people do are not good for transmission longevity at all. The fact is, they make the transmission slam into gear pretty much every single shift.

This is not good on the internal components of the transmission. Things like this are what causes the infamous sprag gears to roll over. An instantaneous hit of power is much harder on the sprag than applying the power smoothly.

Making the Ae transmission survive on the cheap. Part 2 | IS Elite

Drop a hammer on a piece of glass versus lay a hammer on a piece of glass. Use the transmission selector buttons to maintain the gear you want.

Prevent the transmission from downshifting if at all possible under full throttle. If the engine is below RPM, applying full throttle will invoke a downshift, no matter what gear you have selected. There is one way around this — the snow transkission. Your email address will not be published. Previous Post Making the Ae transmission survive on the cheap. Leave a Reply Cancel reply Or. Technical Guides for IS Owners.